Contact   Imprint   Advertising   Guidelines

Rocker table for vacuum bagging for sale

Here you can exchange your experience and datas about your home build boards
mike1978
Rare Poster
Posts: 19
Joined: Fri Nov 21, 2008 1:27 pm
Local Beach: portland
Gear: Ozone Edge
Brand Affiliation: None
Location: Weymouth, England
Has thanked: 0
Been thanked: 0

Rocker table for vacuum bagging for sale

Postby mike1978 » Sun May 20, 2012 10:04 pm

Hi,

I`ve got my rocker table i use for shaping and vac bagging kite boards i make - its pretty well made and fully adjustable - see the pics below.

Looking for £30 - collection only from Weymouth, UK - its pretty heavy!

Cheers, Mike

Image

Image

Image

Image

frankm1960
Very Frequent Poster
Posts: 1229
Joined: Sun Feb 04, 2007 10:48 pm
Local Beach: -Bayshore, at the end sea st. on saint John's west side, bay of fundy.
-Saints rest beach, at the end of sandy point road, irving nature park, saint john, west side.
Gear: Kites: 12m LF Mig, 9m LF Mig, 5m SS Fuel
Boards: LF proof 151cm, Real Wind 144cm, home made light wind board 160 x 50
Brand Affiliation: None
Has thanked: 0
Been thanked: 0

Re: Rocker table for vacuum bagging for sale

Postby frankm1960 » Mon May 21, 2012 2:23 am

Can you create a concave bottom shape with it?

mike1978
Rare Poster
Posts: 19
Joined: Fri Nov 21, 2008 1:27 pm
Local Beach: portland
Gear: Ozone Edge
Brand Affiliation: None
Location: Weymouth, England
Has thanked: 0
Been thanked: 0

Re: Rocker table for vacuum bagging for sale

Postby mike1978 » Mon May 21, 2012 8:30 am

frankm1960 wrote:Can you create a concave bottom shape with it?
Yes - i managed to do create a single concave quite successfully by sliding a thin piece of plastic down the centre underneath the perspex. This raises the perspex very slightly in the middle enabling the concave to be produced while the epoxy sets.

I`ll see if i can dig out picture of it in action somewhere...

mike1978
Rare Poster
Posts: 19
Joined: Fri Nov 21, 2008 1:27 pm
Local Beach: portland
Gear: Ozone Edge
Brand Affiliation: None
Location: Weymouth, England
Has thanked: 0
Been thanked: 0

Re: Rocker table for vacuum bagging for sale

Postby mike1978 » Mon May 21, 2012 8:33 am

here we go -

Image

Image


Return to “Gear Builders”

Who is online

Users browsing this forum: evan and 114 guests