Here you can exchange your experience and datas about your home build boards
-
mike1978
- Rare Poster
- Posts: 19
- Joined: Fri Nov 21, 2008 1:27 pm
- Local Beach: portland
- Gear: Ozone Edge
- Brand Affiliation: None
- Location: Weymouth, England
-
Has thanked:
0
-
Been thanked:
0
Postby mike1978 » Sun May 20, 2012 10:04 pm
Hi,
I`ve got my rocker table i use for shaping and vac bagging kite boards i make - its pretty well made and fully adjustable - see the pics below.
Looking for £30 - collection only from Weymouth, UK - its pretty heavy!
Cheers, Mike
-
frankm1960
- Very Frequent Poster
- Posts: 1229
- Joined: Sun Feb 04, 2007 10:48 pm
- Local Beach: -Bayshore, at the end sea st. on saint John's west side, bay of fundy.
-Saints rest beach, at the end of sandy point road, irving nature park, saint john, west side.
- Gear: Kites: 12m LF Mig, 9m LF Mig, 5m SS Fuel
Boards: LF proof 151cm, Real Wind 144cm, home made light wind board 160 x 50
- Brand Affiliation: None
-
Has thanked:
0
-
Been thanked:
0
Postby frankm1960 » Mon May 21, 2012 2:23 am
Can you create a concave bottom shape with it?
-
mike1978
- Rare Poster
- Posts: 19
- Joined: Fri Nov 21, 2008 1:27 pm
- Local Beach: portland
- Gear: Ozone Edge
- Brand Affiliation: None
- Location: Weymouth, England
-
Has thanked:
0
-
Been thanked:
0
Postby mike1978 » Mon May 21, 2012 8:30 am
frankm1960 wrote:Can you create a concave bottom shape with it?
Yes - i managed to do create a single concave quite successfully by sliding a thin piece of plastic down the centre underneath the perspex. This raises the perspex very slightly in the middle enabling the concave to be produced while the epoxy sets.
I`ll see if i can dig out picture of it in action somewhere...
-
mike1978
- Rare Poster
- Posts: 19
- Joined: Fri Nov 21, 2008 1:27 pm
- Local Beach: portland
- Gear: Ozone Edge
- Brand Affiliation: None
- Location: Weymouth, England
-
Has thanked:
0
-
Been thanked:
0
Postby mike1978 » Mon May 21, 2012 8:33 am
here we go -
Return to “Gear Builders”
Who is online
Users browsing this forum: No registered users and 114 guests