Jackie Treehorn wrote:
... a crease in the underside of my board: about 4 inches long,
Don't Ruin your board there Dude ; it's an Easy Fix.
Measure 2" on ether side of the crease and 1" above & below
& mark with a felt pen.
Sand in Lil circles with 60g paper.
get some 4 0r 5oz glass & mark same as the lines on the board for
the first layer but the second layer is 1/2" smaller and the third
layer is 1/2" smaller than the second.
The glass goes down +-45 deg from the crease on the board so
more fibers intersect the break.
Clean Real good with Denatured alcohol and wet out the glass with
at Least 30min Epoxy ; 60min will give a better bond.
Soak the glass with More epoxy than needed but then take
paper-towels and blot off the excess. Don't Over do-it !!
Not counting Beer, should take you an hour Max !!