I was thinking about an open source courseboard project, something that will be just as fast as the top boards
any ideas are welcome
presumably tri fin setup, unless anyone has other ideas ( 3 with 0 cant, and small extra fins with cant to make the lift? ect)
What shape tail would be best?
any designs where cutouts can be used for an advantage? (noticeable difference <30 knots)
if a very fast design is produced, local board manufacturers can produce, and if they get the tolerance very close, then maybe the 50 boards may not need to be made in 1 factory?, keeps cost down also, only the local manufacturer makes money
extreme and unusual ideas are welcomed, willing to try anything