In light winds on lumpy seas with big surf i'm finding the speed to be very annoying. The chop and swell slows you down so you cant get speed to boost. the slow turning and completely non existant down wind ability is a real pain in the waves. also when you do ride a wave upwind the extra speed powers the kite up and tears you off the wave face.... grrrrr.
I've come to the conclusion that it really is a flat water or land kite.
jakemoore wrote:I am having mixed luck going downwind with speed 3 especially on the raceboard. When I lose line tension, I just fall right into the water, and it takes a minute to build it up again.
Yes i also loop downwind. which is fine unless your on a wave and the wave is pushing you faster than the loop..... then its tack upwind or have an expensive pile of fabric get washing machined in the surf.
Have you done a mixer test and checked your SPL length?
SPL = spare parts line = the bright yellow lines that go through the pulleys... they can shrink A LOT and bork up the handling..
Ram airs suck at racing.
Ram airs collapse and twist on downwind legs.
Ram airs suck in chop and waves - THEY ARE A FLAT WATER OR LAND KITE (if that).
Ram airs cause the rider to fall into the water on the downwind legs. Often you end up with an "expensive pile of fabric getting washing machined in the surf!!!
Make sure you spend hours and hours checking the mixer and your SPL and your line lengths (cos they shrink and bork up). A degree in basket weaving will help. After all those hours, your kite will still suck.