Jack C wrote:I have an "Old" 2008 cabrinha xbow 3 that was given to me
by a buddy. It's in really good shape and I have used it several times.
My question is, on that cabrinha powerdrive 2n1 bar, yes the dredded
bar pressure bar, is it possible to run a line through the bar to the ring
up top to the single front line flagging ring? This would be to connect the
leash below the bar. Otherwise it's always in suicide mode leash attachment.
Anyone tried this?
Any Idea's??? or just forget about it?
for sure, I mod my bars all the time. You need to lark's head some ordinary kite line that you splice to replace the current flagging line with flagging ring on that cab 2008 because it will have to go through the bar. So you need to know how to splice kite line. Then take that stainless steel swivel and replace it with a flagging block. When I make them I just get a 1x1 inch block of nylon and drill four holes, two big holes in the center to hold the center line strap, and too smaller holes at the edges. The smaller edge holes will have about 2mm (size of kite line) on the kite side and about 3mm (flagging line) on the bar size. Create a new flagging line that goes into your bar it will be made of slightly thicker line than kite line. If you want to nondestructive mod the chicken loop, just add a stainless steel ring lark's headed there and pass the line flagout line through it. Put everything together. Once you are finished it will be much the same as any other center line flagging system.
If this is hard to understand, go grab a liquid force, silngshot or ozone bar and just see how they do it.
You are giving up the swivel to make this mod if that matters. Not that swivels work that good anyways.
Hate those 2 for 1 bars. I have an assault that used to run on a 2 for 1 bar and I kept modding the bridle until I could get it to work on a 1 for 1 bar.