*


All times are UTC + 1 hour



Post new topic Reply to topic
 [ 13 posts ]  Go to page Previous  1, 2
Author Message
 Post subject:
PostPosted: Tue Jul 08, 2003 3:39 pm 
Offline
Medium Poster
User avatar

Joined: Wed May 21, 2003 3:06 pm
Posts: 74
Location: Perth
No problem Cactus
The vac hose goes through the top sheet from underneath should explain it better.
But I put a rough pic in the gallery anyway "Australia, pjgold123"

Cheers
Pete


Top
Profile
 Post subject:
PostPosted: Wed Jul 09, 2003 2:03 am 
Offline
Very Frequent Poster

Joined: Thu Feb 20, 2003 7:14 pm
Posts: 584
Pete,

What type of bit do you use to router out the slot in your rocker table?

How well does it hold a vacuum?

That sounds like a great way to do it.

Trent


Top
Profile
 Post subject:
PostPosted: Wed Jul 09, 2003 5:48 am 
Offline
Medium Poster
User avatar

Joined: Wed May 21, 2003 3:06 pm
Posts: 74
Location: Perth
I use a normal straight cut bit 5mm wide 5mm deep and a length off fly screen door spline rubber for the seal, but you could use 6mm or 1/4" what ever as long as the tube or rubber you use is a tight fit in the slot.
If you don't have a router another way to do it is to get some aluminum channel or fly screen frame, screw it to your table and seal with a bit of silicon.
It seals well I had no problems getting 20hg with a small fridge pump and get more with my new pump.
You can also put some silicon in the slot if you have trouble with the seal, you just have to cut it out after each use.

Cheers
Pete :thumb:


Top
Profile
Display posts from previous:  Sort by  
Post new topic Reply to topic
 [ 13 posts ]  Go to page Previous  1, 2

All times are UTC + 1 hour


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group