It is no secret. Like I said, it is a 3 layer ply. 3,5 mm thick. Top layers are 1 mm thick Paulownia, the grain runs longitudinal, the midle layer is 1,5 mm thick Balsa and the grain perpendicular to lenght of the sheet. Dimentiones are approx. 2420 x 1220 mm.
I would also like to find a supplier, because where I buy it, I have to go through hundreds of plates, to find 3 or 4 I could use. I prefer this Pau-Bals combination over Okoume. It is much lighter and flexier and easier to work with.
I already presented some of my boards here. I still make a lot of progress with each new board I make, so this tells me I am stil far from perfect. Curently my biggest strugles are pouring the epoxy rail without having to correct it 2 or 3 times to get the whole rail (I prepress the core, than pour the rail, than apply the top shets). The other strugle is how to get finished surface without air traped beneath the top sheet or precured glass.
I shot 360 GB of pictures for Timelapse of building/modifying the rocker table for new composit wood Alaia and building the board. However, now when I am finished with the board, I have to make a video of my snowkiting vacation in Erciyes in Marh/April
, than I will start on these Timelapses.
Some recent boards: