hi, board numver 4
only at the begining
non symetrical, 140 x 45 finished, to get into my bag
is going to be 2 full plys of 1/8 baltic and one little piece of same ply cente for the inserts and pads.
going to glue it on the rocker table, then poor a epoxy rails, shape it a bit, and laminate bottom and then top under vac without rocker table.
is going to be one layer of 8.9 oz carbon x basalt plus one 2 or 3 ( thin one ) layer of glass to cover it, some colored carbon tape under for visibility and reinforcement.
just wondering what glue to use : epoxy ( strong but heavy)
: urethane ( not so strong but is going to expande and fill the hollows )
: waterproof wood glue ( cheapest lightest, strong )
comments on the glue ???
center piece is the bottom, above is the top, and on th bottom of the pic you can see the little center piece.
you can see how the cuts are crossing eachother
and how the light is showind throu