Hello guys,
I purchased a Naish Park 2011 10m + Universal Bar 2011 (new) back in 2011.
Recently my lines got cut and after asking several Naish Agents I could not get an answer to my problem. I'm really hoping you can help me.
I bought a set of brand new lines as follows:
- 1 pair of Middle/Gray Lines = 17m (connected to the already existing 3m single middle line = total 20 meters)
- 1 pair of Rear/back Lines = 20m
The above setup has screwed the behaviour of my kite. The middle lines appear to be shorter (powering up the kite). I immediately realized that there are 1.35m BLUE/RED extension lines at the rear part of the kite (on which the rear lines of the bar attach to; These extensions were already there when I bought the kite from Naish)
I also remembered the RED/BLUE Extension lines attached on the Universal Bar 2011 from where we power/depower the kite).
So I then tried to connect my 20m rear lines directly onto the kite removing the BLUE/RED Extensions but this time the Rear lines were shorter than the Middle/Grey lines!
So I'm really puzzled as to what is the correct Lines setup!
There is no reference anywhere on the exact dimensions of all the line parts of the Naish Park 2011.
The photo shows a diagram of the Naish Park/Universal bar setup (the same photo as I have in the guide I received from Naish) but it does not say how long the lines need to be.
Does Anybody here know how the LINES should be setup on a NAISH Kite using the NAISH Universal bar? Does anybody know the correct dimensions for all the following lines that are part of the Naish Park 2011 setup?:
- bridle lines length
- BLUE/RED Extension lines length (these are attached to the kite)
- grey lines length,
- Rear lines length
- Single Middle line length
- length of the RED/Blue lines (attached to the Universal Bar)
With the above information perhaps I can see where I went wrong!
I hope there is at least one person who had to replace his Naish Lines on a 2011 model
thx