Hi my second build hope you like it.
using a wood plane to get the tips down to 3 mm
i am using to use a mixture of epoxy, glass fiber and glass bubbles for the insert holes and stainless steel snowboard inserts.
setting up the rocker tabel to 5 cm center.
the center of the board is 8mm and sloping down to the tips to 3mm, on the underside i made 3D water guide's.
laying up the carbon (220 ud) for extra strength in the center and at the fin tips,
friend of mine broke his board at those points so i gave those points some extra attention.
got the bottom done looking smooth need to sand down some spots, i am going to do a epoxy hot coat after i sanded the bottom and then put some UV lacquer on.
did the top side, lay up glas 2x220ud 1x185kepper and 220ud carbon for the footpads, added some carbon strips that i had left over for decoration.
Hope you like my new kitaboard!
i will post some more pictures after i have sanded, polishd and buffed the board.
greatz form Holland