Thanks, I found it now, halfway down this pageSENDIT! wrote:It's called a Cabrinha Line Manager, Peter. It's used to keep your lines untangled when you disconnect them prior to wrapping them up. Comes with every Cabrinha kite.
Hi PeterPeter_Frank wrote:Thanks, I found it now, halfway down this pageSENDIT! wrote:It's called a Cabrinha Line Manager, Peter. It's used to keep your lines untangled when you disconnect them prior to wrapping them up. Comes with every Cabrinha kite.
A physical "line end holder"
Earlier, I remembered it as a clever way of hooking the line ends up on each other, like this: viewtopic.php?t=2381114&p=800820
As I stated above I used that method after I lost my line manager. I felt as though the lines could easily invert on themselves,it works but not as nice as the manger does.OzBungy wrote:There's a much easier and more convenient way of doing it. Just lark's head the ends of the lines together.
You can be extra careful and keep the lines straight, but I don't bother. I just drop the ends on the ground, wind out the lines, walk back the ends, un-lark's head them and connect them to the kite.
This is the connect straight to the kite method, but I a) can't be bothered being careful, and b) would prefer to check the lines and knots rather than relying on a tricky system.
Here's the Cabrinha video.
Yep I get it, and have done this since I lost my line manager, I just prefer the line manager .experienced1 wrote:when you disconnect your lines from th kite, just tie the red outside line to the "red" front line and then the gray outside line to the "gray" front line
Users browsing this forum: No registered users and 16 guests