Contact   Imprint   Advertising   Guidelines


here you can exchange your experience and datas about your home build boards

User avatar
Frequent Poster
Posts: 221
Joined: Wed Nov 06, 2002 1:00 am
Kiting since: 0
Brand Affiliation: None
Location: Hamburg, Germany


Postby Jan:) » Tue Sep 09, 2003 9:53 am

How do you get them to the foam, what tools do you use?

not annonymous
Very Frequent Poster
Posts: 587
Joined: Thu Feb 20, 2003 7:14 pm

Postby not annonymous » Tue Sep 09, 2003 4:16 pm

A good way to get a nice fair concave is to use a router with a straight bit. set the router for the deepest part of the concave and run it down the center of the board, then reduce the depth setting to make parallel passes on each side of the centerline.

Once you have the depth of the concave marked out in several places, you can use coarse sandpaper or a surform to remove the material in between the grooves you routed out.

Very Frequent Poster
Posts: 975
Joined: Wed Nov 20, 2002 1:00 am
Kiting since: 0
Brand Affiliation: None
Location: rhode island

Postby zfennell » Tue Sep 09, 2003 5:18 pm

put the concave in your rocker table.
clamp the foam to the table
the concave will set when you laminate
either the core or the skin.


Return to “Board Builders”

Who is online

Users browsing this forum: No registered users and 3 guests