5th Element 2005
Brand: North
Sizes:
- One Size
Contents |
Description
Manual
Nose Down Relaunch
Y-Connection Trim PDF
Pictures
Videos
Reviews
Trim Tips
Y-Connection Trim
As your bar will hopefully get used a lot, there are defiantly places on the system that will have some wear. In our research department we discovered a new option to customize your bar at the top Y connection, so your system will not wear out. Just take a few minutes and change your lines after the following instruction.
1: Your system will look like this picture.
2: Separate the blue midline by opening the loop and remove it. Then connect the two lines again.
3: Cut a piece of an old flying line with the length of 10 cm or a little bit more. Tie a figure eight knot to both sides of the line.
4: Now open the red and the grey loops that are still connected to the grey line. Feed the little line through the loops so that you get a loop that will have the blue midline running through.
5: In the next step feed the knots even one loop further and tighten the red and blue loop back.
Now you have the big advantage that if after a lot of use the loop will tear you can still fly your kite back to the beach and easily go over all the steps and make a new loop connection.
